IPv6 Neighbor Discovery (ND) Proxy, Oh My!

In a couple of blogs and I had mentioned ND-PROXY.

ND-PROXY is an IPv6 Neighbor Discover Proxy, it allows a router or a node to respond to IPv6 Neighbor Solicitations (NS) messages.

It does this on behalf of hosts located on another segment within the same sub-net or prefix.

It is useful for example if you have /64 prefix and want to put wireless clients on it but do not want to use an existing prefix or you ISP only gave you a /64 (the nerve!).

I will go over a configuration on a Linux server stitching a couple of IPv6 segments.

Continue reading “IPv6 Neighbor Discovery (ND) Proxy, Oh My!”

Kea, DhcpV6, DDNS, Ubuntu 26, Oh My!


Hello there,

A while back, in a galaxy far away, I had a blog (and related posts) about using the ISC DHCP server.

That setup worked very well. However, the ISC DHCP server has been discontinued.

So it was time to try the Kea DHCP server.

It should be a standard setup, Kea is a modern replacement however, I run into a few quirks and it did not help that I was using the latest Ubuntu server version 26.

Continue reading “Kea, DhcpV6, DDNS, Ubuntu 26, Oh My!”

NAT64 Lab Using Cisco’s ASR and DNS64 (Maybe).

Hello again,

The other day I came across a configuration by Cisco in regard to NAT64.

As you are aware, NAT64 permits IPv6 only networks to access IPv4 networks and vice versa.

Of course, they are not entirely IPv6 only networks since they probably have an IPv4 gateway somewhere allowing them to access IPv4 networks on the Internet.

I decided to do the lab and test it using EVE-NG. Continue reading “NAT64 Lab Using Cisco’s ASR and DNS64 (Maybe).”

Hostapd Revisited. Using Bridging for IPv4 and IPv6.

Hello,

In a previous post, I have shown a configuration using Hostapd, Ubuntu and a Belkin USB dongle allowing me to have Wi-Fi access.

This work reasonably well but the speed of the dongle was 54 Mbps only.  So I decided to buy a Panda PAU06 Wireless N USB adapter.

The reason was that Panda claimed it was Linux compatible and it will operate at 150 Mbps. I know 150 Mbps is so slow nowadays, but I do not need that much speed on the WLAN, all my devices are wired with Gigabit speed.

I do not have several people competing for bandwidth also.

If I need to stream something I use, the media center connected to a big-screen TV.

This setup actually worked fairly well, using Fedora 29 on VMWARE Workstation.

The setup used routing and that created some issues with the “/64” prefixes I am given by my provider that you can read in that post.

Well, I accidentally deleted the VM guest the other day, yes I had no backup but I am always careful, this time it bit me in the behind.

Thus this time I decided to re-do the setup but instead use bridging to connect the LAN and WLAN interfaces. This is working rather well, so read on. Continue reading “Hostapd Revisited. Using Bridging for IPv4 and IPv6.”